- Wed May 01, 2013 8:02 pm
#678
Here is an initial scetch of my design:
Some details:
Some details:
- There is no floor because then I can mount the machine anywhere on any flat surface and not be limited by the machine build size
- I am planning on using stainless steel or all aluminium for the frame
- The entire frame is 1 x 1 meter
- The shafts are 30" (76 cm)
- The y-axis motor is mounted on one of the sides, I'm planning on using a wire to tranfer the motion to the other side
- There are 2 Shafts on each side to increase travel in y-direction and to add support. (hmm... doesn't seem to be possible to order more of those shaft supports on the webstore, but I guess they will be available soon)
- I didn't add everything to the 3d-model, so it only shows the priciples. I'll post updates later
Last edited by frodeheg on Mon Aug 26, 2013 4:17 pm, edited 1 time in total.