Page 1 of 1

z-axis status?

Posted: Mon Mar 02, 2015 6:17 pm
by pgf
Hi -- I'm a little confused about the status of the Z-axis "building block". The pictures of the injection molded assembly don't look anything like the $149 Z-axis (of aluminum?) pictured in your store. They're clearly not the same thing -- is the injected molded version not available?

Or... perhaps I've simply arrived too late to this party?

paul

Re: z-axis status?

Posted: Thu Mar 12, 2015 10:54 am
by AJ Quick
We ran into manufacturing problems with the injection molded parts.

The aluminum version (much better than plastic, but more expensive) replaced the plastic building blocks.