Page 1 of 1

Update #24: First Production Z-Axis Done

Posted: Fri Apr 01, 2011 9:00 pm
by AJ Quick
Just a quick update. The process of making the Z-axis from plastic has begun and is proving to be a time consuming process. The amount of time required for each of the components is likely to be closer to 5-6 hours vs. 2-3 hours. It will slow down the process a little bit. Here are some photos of a completed unit (sans motion components).

Sorry for the poor cell phone photos.

We also have recieved notice that the stepper motors have been produced and have shipped!

Image

Image