- Fri Jun 29, 2012 4:58 pm
#582
I've got my controller kit soldered together except for the motor drivers, at the stage of the documentation to test voltages.
My 5V test point has 12V on it, and my fan output has 5V on it.
Shouldn't matter, but running a 24V input, double checked my polarity right at the controller's DC input point.
I've double checked all of my components, even comparing visually to the pictures in the installation guide, nothing is out of place. I've checked my solder connections and don't see any bridges or apparent cold solder joints. I've even reheated the joints that didn't look picture perfect.
Any ideas, AJ?
My 5V test point has 12V on it, and my fan output has 5V on it.
Shouldn't matter, but running a 24V input, double checked my polarity right at the controller's DC input point.
I've double checked all of my components, even comparing visually to the pictures in the installation guide, nothing is out of place. I've checked my solder connections and don't see any bridges or apparent cold solder joints. I've even reheated the joints that didn't look picture perfect.
Any ideas, AJ?