The electronics that take the impulses from the computer and make the motors turn.
By Rifraf
#633
AJ,

I just picked up one of your older BiPolar boards on eBay. Do you have a manual for the controller that comes with it, other than the setup guide on your website? I was wondering if the board had the ability to interface limit switches and/or other pins on the parallel port? I was thinking it would be nice to look into a relay board to let the software control the spindle.

Thanks!

Steve, Thanks for letting us know. I believe the[…]

What are your DIP switches set to? They can cause […]

CNC electronic questions?

AJ, Thanks a lot for your help,

Testing the 3 Axis Controller

I had replied to your email, but I'll post this he[…]