CNC.xyz

AJ,

I just picked up one of your older BiPolar boards on eBay. Do you have a manual for the controller that comes with it, other than the setup guide on your website? I was wondering if the board had the ability to interface limit switches and/or other pins on the parallel port? I was thinking it would be nice to look into a relay board to let the software control the spindle.

Thanks!

Checkout this thread here:

http://www.aquickcnc.com/forums/viewtopic.php?f=12&t=92

There is some information about that about 1/2 way down the page.