Breakout on bipolar cnc board?
Posted: Mon Nov 05, 2012 8:01 pm
AJ,
I just picked up one of your older BiPolar boards on eBay. Do you have a manual for the controller that comes with it, other than the setup guide on your website? I was wondering if the board had the ability to interface limit switches and/or other pins on the parallel port? I was thinking it would be nice to look into a relay board to let the software control the spindle.
Thanks!
I just picked up one of your older BiPolar boards on eBay. Do you have a manual for the controller that comes with it, other than the setup guide on your website? I was wondering if the board had the ability to interface limit switches and/or other pins on the parallel port? I was thinking it would be nice to look into a relay board to let the software control the spindle.
Thanks!